When the brake lever switch is worn out, it locks in the “on” spot even if you apply the off control. This part controls the speed controller to turn off when the brakes are applied. Test Brake Lever SwitchĬheck the brake lever switch on your e-scooter. If the output comes different than the mark, the charger is faulty. The standard voltage level is 24V or 36V. After this, use a multi-meter to measure the output voltage. If the warning light is not illuminated or only flashes on and off, the charger is faulty.

If water gets leaked into it or even dirt, the battery can get turned off easily.įirstly, to inspect your battery, plug it into a power outlet, and check for some indication light. The battery needs regular and proper maintenance. If they somehow get damaged, then it can have an effect on the electric motor. The battery gives the electric scooter the long run’s ability, and the charger charges the battery. So you need to replace the electric motor at once! 3. When the plastic insulation melts off the magnet winding, it shortens the circuit, and you have an electric scooter motor not running. If you get the smell, the coils may have been overheated, and the speed controller could have been affected. Check the motor, controller, and other electrical parts. Look For Any Burned Wireĭue to overload and heavy-duty, the electric wires may burn sometimes. Gently give the wires a tension, and if there is any loose or disconnected wire, it will come out! 2. In that case, you may have an electric scooter motor not running. Suppose the wiring inside the electric motor gets loose or disconnected. The motor remains connected to different parts through wires. The most common problem that occurs is loose cables. From simple loose wire connection to major engine problems, here are some of the ways to electric scooter motor troubleshooting. You may find your electric scooter motor not running while you try to start the scooter. Yet, they are weak and are unable to maintain an adverse state. On the other hand, brush-less engines are more powerful and have fewer moving parts. These engines can handle more driving pressure, but they’re a little less powerful. They’re more powerful than the geared ones. Gearless motors are typically wide and powerful, but they give more torque and power to the electric scooter. Geared hub motors are smaller in size, providing increased range but less power.The hub motors come in different shapes and designs, and they vary from each other. Otherwise, it can result in the electric scooter motor not running. But as the hub motor delivers the power to the wheels since they are a mechanical device, they need maintenance or repairing. The motor transfers power to the wheels through a shaft, and by this, the electric scooter runs. To keep the design intact and make the vehicle more efficient, the hub or electric motors are connected to the scooter’s front or rear wheel. But other than this, hub motors are also used sometimes. How do I fix my electric scooter motor?įrom the name itself, you can easily understand that electric motors are used in electric scooters.How does an electric scooter motor work?.

Electric scooter motor